Knauf Insulation Removal & Replacement Nationwide

Knauf Insulation Removal & Replacement in Georgetown: What to Know First

We provide independent Knauf insulation removal and replacement in Georgetown, with most residential jobs completed in one day and a written price delivered before any work starts. As an independent Knauf service provider, we are not affiliated with or authorized by Knauf - we are a local building-envelope contractor that sources Knauf materials alongside Owens Corning, Johns Manville, and other manufacturers, and we remove failed Knauf systems when they no longer perform. Most homeowners in Georgetown who call us about Knauf insulation are dealing with compressed batts in attics above 140°F, moisture-compromised EcoBatt in vented crawl spaces, or blown-in Jet Stream Ultra that has settled below its labeled R-value. Call (254) 970-2136 for a free estimate with a written price before any work starts.

Call (254) 970-2136

How Knauf Products Fail - and How We Fix Them

• EcoBatt Glass Mineral Wool batts in Georgetown crawl spaces absorb ground moisture during our humid spring months when vapor barriers are missing or compromised. The brown ECOSE binder breaks down, the batts sag between joists, and the effective R-value drops by 30 to 50 percent before homeowners notice musty odors. We remove the degraded batts, install a polyethylene vapor barrier or full encapsulation if indicated, then replace with properly supported batts or conditioned-crawl foam depending on the moisture profile.
• Jet Stream Ultra blown-in fiberglass in Sun City Georgetown attics settles faster than cellulose in homes with significant stack-effect pressure - the natural upward pull of warm air that accelerates in homes with unsealed top plates. We see this in ranches built 2015 to 2020 where the original installer skipped air sealing. Our fix: remove the settled material, foam-seal every penetration and top plate joint, then reinstall to a measured, documented depth with density-checked blowing.
• Insulation board (Knauf PermaBATT or rigid polyiso assemblies) in homes near the San Gabriel River corridor often shows rodent compression and nesting, particularly where soffit screens failed. The boards crush to half thickness, creating thermal bridges. We remove the contaminated boards, photograph the damage for insurance documentation, rodent-proof the entry paths, and replace with new board or switch to spray foam on the roof deck if the HVAC is in the attic.
• Knauf batts installed pre-2016 with Kraft paper facing trap humidity in Georgetown’s shoulder seasons when attic ventilation is marginal. The paper delaminates, the fiberglass compresses, and mold colonizes the interface. We remove the facing and batt together - never try to separate them in place - then evaluate whether the roof deck needs treatment before new unfaced batts or blown-in replacement.
• Knauf Attic Access Insulation Covers - the tent-style units over pull-down stairs - detach at the staple flange or zipper after repeated summer heat cycling. We see this in Cedar Park-adjacent Georgetown homes where the attic hits 150°F. We replace with a higher-R rigid cover or build a custom dam with sealed rigid foam, depending on stair geometry and your access frequency.

Our Knauf Insulation Removal & Replacement Process

1. 1
   Call and scheduling. A live person answers 24/7. We book a diagnostic visit with a named technician; you get a text when they are en route under Haven Standard: Arrive on schedule.
2. 2
   On-site diagnostic and blower-door test. We run a blower-door test - a pressurization reading that shows, in one number, how much air your building envelope is losing. We photograph existing Knauf products, note series and condition, and check for contaminants (rodent, mold, asbestos-suspect vermiculite).
3. 3
   Written price and scope. You receive a flat price, written scope, and written warranty before anyone lifts a tool. Haven Standard Clause 1. No exceptions.
4. 4
   Air sealing first. Seal the holes first. Then we talk about R-value. We foam-seal top plates, can lights, plumbing and electrical penetrations, and duct boots before any new insulation touches the attic floor.
5. 5
   Removal and replacement. We remove failed Knauf material with HEPA-contained vacuums, dispose per local code, and install replacement insulation - Knauf, Reflectix, or another manufacturer depending on your performance goals and our thermal imaging results.
6. 6
   Documentation and closeout. You receive a Documented Photo Record, before-and-after blower-door numbers on applicable jobs, and measured R-values with duct-leakage test results. The 365-Day Done Right Promise is in writing.

Before

After

What Knauf Insulation Removal & Replacement Costs in Georgetown

Most attic insulation removal and replacement jobs in Georgetown homes run between $2,800 and $5,400, depending on square footage, contamination level, and whether air sealing is included. Crawl space EcoBatt removal with vapor barrier replacement typically falls between $3,200 and $6,100. Jet Stream Ultra removal and re-blow with full air sealing runs $4,500 to $8,200 for attics over 2,000 square feet.

What moves the price: accessibility (steep roof pitch or limited attic hatch), presence of rodent contamination requiring PPE and HEPA containment, and whether we find failed ductwork that needs sealing before new insulation goes in. We do not price by the bag; we price by the measured performance outcome.

Bring us any written estimate - we offer a Free Second Opinion on any written estimate, and we’ll read it with you line by line. Call (254) 970-2136 for a written price before any work starts.

Why Georgetown Homeowners Call Topside Attic Insulation Georgetown for Knauf Work

We’ve sealed and insulated more than 9,000 homes since 2016, and we publish before-and-after blower-door numbers on every applicable job so you can verify the air-sealing result you paid for. Wes Okafor and our crew have worked attics from Sun City Georgetown to homes backing up to the San Gabriel River corridor, and we source materials from Knauf, Reflectix, Owens Corning, Johns Manville, and others - no proprietary lock-in that limits your options.

Our technicians are background-checked and uniformed. Calls are answered by a live person, 24/7. Every job closes with a Documented Photo Record and the 365-Day Done Right Promise in writing. If it’s not done right, we make it right.

FAQs